Table 5. Cli Command Modes - D-Link DWL-8500AP Command Reference Manual

Table 5. CLI Command Modes

Command
Mode
User EXEC
Switch>
Privileged EXEC
Switch#
Global Config
Switch (Config)#
VLAN Config
Switch (Vlan)#
Interface Config
Switch (Interface <slot/port>)#
Switch (Interface Loopback <id>)#
Switch (Interface Tunnel <id>)#
Line Config
Switch (line)#
Policy Map
Switch (Config-policy-map)#
Config
Policy Class
Switch (Config-policy-class-map)#
Config
Class Map Config
Switch (Config-class-map)#
MAC Access-list
Switch (Config-mac-access-list)#
Config
TACACS Config
Switch (Tacacs)#
DHCP Pool
Switch (Config dhcp-pool)#
Config
1 Using the Command-Line Interface
Prompt Mode Description
Contains a limited set of com-
mands to view basic system
information.
Allows you to issue any
EXEC
command, enter the VLAN
mode, or enter the Global Con-
figuration mode.
Groups general setup commands
and permits you to make modifi-
cations to the running configura-
tion.
Groups all the VLAN com-
mands.
Manages the operation of an
interface and provides access to
the router interface configura-
tion commands.
Use this mode to set up a physi-
cal port for a specific logical
connection operation.
Contains commands to config-
ure outbound telnet settings and
console interface settings.
Contains the QoS Policy-Map
configuration commands.
Consists of class creation, dele-
tion, and matching commands.
The class match commands
specify Layer 2, Layer 3, and
general match criteria.
Contains the QoS class map
configuration commands..
Allows you to create a MAC
Access-List and to enter the
mode containing MAC Access-
List configuration commands.
Contains commands to config-
ure properties for the TACACS
servers.
Contains the DHCP server IP
address pool configuration com-
mands.
Command Modes 31