CLI Command Reference
no switchport protected (Global Config)
Use this command to remove a protected port group. The
of protected ports. Use the
Format
Mode
switchport protected (Interface Config)
Use this command to add an interface to a protected port group. The
identifies the set of protected ports to which this interface is assigned. You can only configure
an interface as protected in one group.
NOTE:
Default
Format
Mode
no switchport protected (Interface Config)
Use this command to configure a port as unprotected. The
of protected ports to which this interface is assigned.
Format
Mode
show switchport protected
This command displays the status of all the interfaces, including protected and unprotected
interfaces.
Format
Modes
Group ID
Name
List of Physical Ports List of ports, which are configured as protected for the group identi-
show interfaces switchport
This command displays the status of the interface (protected/unprotected) under the groupid.
Format
66
© 2001- 2008 D-Link Corporation/D-Link Systems, Inc. All Rights Reserved.
name
no switchport protected <groupid> [name]
Global Config
Port protection occurs within a single switch. Protected port configuration
does not affect traffic between ports on two different switches. No traffic for-
warding is possible between two protected ports.
unprotected
switchport protected <groupid>
Interface Config
no switchport protected <groupid>
Interface Config
show switchport protected <groupid>
Privileged EXEC
User EXEC
The number that identifies the protected port group.
An optional name of the protected port group. The name can be up to 32
alphanumeric characters long, including blanks. The default is blank.
fied with
<groupid>
field is blank.
show interfaces switchport <slot/port> <groupid>
keyword to remove the name from the group.
. If no port is configured as protected for this group, this
parameter identifies the set
groupid
parameter
<groupid>
parameter identifies the set
groupid