Show Wireless Peer-Switch; Local Access Point Database Commands; Ap Database - D-Link DWL-8500AP Command Reference Manual

show wireless peer-switch

This command displays status information for peer Unified Switches. If no parameters are
entered, the command will display summary status for all peer switches. If a peer switch IP
address is entered, detailed status for that peer switch is displayed.
Format
Mode
ipaddr
IP Address
Vendor ID
Software Version Version of switch software on the peer switch.
Protocol Version Protocol version of switch software on the peer switch.
Discovery Reason Method for peer switch discovery.
Age

Local Access Point Database Commands

The commands in this section provide configuration of the local valid AP database. These
configurations may also be performed on an external RADIUS server.

ap database

This command adds an AP to the local valid AP database (if not already present) and enters
the AP configuration mode identified by the AP MAC address. In AP configuration mode,
you can configure parameters for each individual valid AP. Note that if a valid AP is already
being managed by the switch, you need to reset the AP to pick up any configuration changes in
the valid AP database. The valid AP database parameters are read only when the AP is
validated during discovery.
Format
Mode
macaddr
no ap database
The version of this command deletes the AP from the local database.
no
Format
Mode
show wireless peer-switch [<ipaddr>]
Privileged EXEC
The <ipaddr> is a valid IP address.
IP address of the peer switch.
The peer switch software vendor ID.
Time since last update was received from the switch.
ap database <macaddr>
Wireless Config
MAC address of a physical AP.
no ap database <macaddr>
Wireless Config
4 Wireless Commands
Local Access Point Database Commands 155