Vlan Pvid; Vlan Tagging; Vlan Association Subnet - D-Link DWL-8500AP Command Reference Manual

You should create the referenced VLAN before you create the protocol-based VLAN except
when you configure GVRP to create the VLAN.
Default
Format
Mode
no protocol vlan group all
This command removes all interfaces from this protocol-based VLAN group that is identified
by this
<groupid>
Format
Mode

vlan pvid

This command changes the VLAN ID per interface.
Default
Format
Mode
no vlan pvid
This command sets the VLAN ID per interface to 1.
Format
Mode

vlan tagging

This command configures the tagging behavior for a specific interface in a VLAN to enabled.
If tagging is enabled, traffic is transmitted as tagged frames. If tagging is disabled, traffic is
transmitted as untagged frames. The ID is a valid VLAN identification number.
Format
Mode
no vlan tagging
This command configures the tagging behavior for a specific interface in a VLAN to disabled.
If tagging is disabled, traffic is transmitted as untagged frames. The ID is a valid VLAN
identification number.
Format
Mode

vlan association subnet

This command associates a VLAN to a specific IP-subnet.
none
protocol vlan group all <groupid>
Global Config
.
no protocol vlan group all <groupid>
Global Config
1
vlan pvid <1-3965>
Interface Config
no vlan pvid
Interface Config
vlan tagging <1-3965>
Interface Config
no vlan tagging <1-3965>
Interface Config
2 Switching Commands
VLAN Commands 59