GVRP Commands
This section describes the commands you use to configure and view GARP VLAN
Registration Protocol (GVRP) information. GVRP-enabled switches exchange VLAN
configuration information, which allows GVRP to provide dynamic VLAN creation on trunk
ports and automatic VLAN pruning.
If GVRP is disabled, the system does not forward GVRP messages.
NOTE:
set gvrp adminmode
This command enables GVRP on the system.
Default
Format
Mode
no set gvrp adminmode
This command disables GVRP.
Format
Mode
set gvrp interfacemode
This command enables GVRP on a single port (Interface Config mode) or all ports (Global
Config mode).
Default
Format
Modes
no set gvrp interfacemode
This command disables GVRP on a single port (Interface Config mode) or all ports (Global
Config mode). If GVRP is disabled, Join Time, Leave Time and Leave All Time have no
effect.
Format
Modes
show gvrp configuration
This command displays Generic Attributes Registration Protocol (GARP) information for one
or all interfaces.
Format
disabled
set gvrp adminmode
Privileged EXEC
no set gvrp adminmode
Privileged EXEC
disabled
set gvrp interfacemode
Interface Config
Global Config
no set gvrp interfacemode
Interface Config
Global Config
show gvrp configuration {<slot/port> | all}
2 Switching Commands
GVRP Commands
69