Radius Server Primary; Radius Server Retransmit; Radius Server Timeout - D-Link DWL-8500AP Command Reference Manual

CLI Command Reference
no radius server msgauth
This command disables the message authenticator attribute for a specified server.
Format
Mode

radius server primary

This command is used to configure the primary RADIUS authentication server for this
RADIUS client. The primary server handles RADIUS requests. The remaining configured
servers are only used if the primary server cannot be reached. You can configure up to three
servers on each client. Only one of these servers can be configured as the primary. If a primary
server is already configured prior to this command being executed, the server specified by the
IP address specified used in this command will become the new primary server. The IP address
must match that of a previously configured RADIUS authentication server.
Format
Mode

radius server retransmit

This command sets the maximum number of times a request packet is re-transmitted when no
response is received from the RADIUS server. The retries value is an integer in the range of 1
to 15.
Default
Format
Mode
no radius server retransmit
This command sets the maximum number of times a request packet is re-transmitted, to the
default value.
Format
Mode

radius server timeout

This command sets the timeout value (in seconds) after which a request must be retransmitted
to the RADIUS server if no response is received. The timeout value is an integer in the range
of 1 to 30.
Default
Format
Mode
320 © 2001- 2008 D-Link Corporation/D-Link Systems, Inc. All Rights Reserved.
no radius server msgauth <ipaddr>
Global Config
radius server primary <ipaddr>
Global Config
4
radius server retransmit <retries>
Global Config
no radius server retransmit
Global Config
5
radius server timeout <seconds>
Global Config