Show Wireless Rates - D-Link DWL-8500AP Command Reference Manual

CLI Command Reference
Long Retry Limit Indicates the maximum number of transmission attempts on frame sizes
Maximum Transmit Lifetime Indicates the elapsed time after the initial transmission of an
Maximum Receive Lifetime Indicates the elapsed time after the initial reception of a frag-
Maximum Clients Maximum number of simultaneous associations allowed on the interface.
Automatic Channel Adjustment Indicates if automatic channel adjustment is enabled. If
802.11a Limit Channel Selection Indicates if the auto channel algorithm will limit the
Automatic Power Adjustment Indicates if automatic power adjustment is enabled. If
Default Power Indicates a default power setting for the radio. If automatic power adjustment
Supported Rates Indicates what data rates the AP will support in setting up communications
Advertised Rates Indicates what data rates the AP will advertise to clients in its beacons.
Load Balancing Indicates if the AP will load balance users on this radio.
Load Utilization If load balancing is enabled, % of network utilization allowed on the radio
Station Isolation Indicates whether Station Isolation is enabled. When Station Isolation is

show wireless rates

This command displays the rates valid for a specified physical mode. This is intended to help
you determine valid values for the
Format
Mode
Mode
Valid Rates
182 © 2001- 2008 D-Link Corporation/D-Link Systems, Inc. All Rights Reserved.
greater than the RTS Threshold. This is a read-only value and cannot be con-
figured.
MSDU, after which further attempts to transmit the MSDU shall be termi-
nated. This is a read-only value and cannot be configured.
mented MMPDU or MSDU, after which further attempts to reassemble the
MMPDU or MSDU shall be terminated. This is a read-only value and cannot
be configured.
enabled, the initial AP channel assignment can be automatically adjusted by
the switch due to changes in the network.
802.11a channel selection to a pre-defined set of values. This value is only
displayed for 802.11a mode.
enabled, the switch may modify the power on the radio due to changes in per-
formance.
is disabled, this indicates a fixed power setting, otherwise it indicates the ini-
tial power setting before any automatic adjustments.
with client stations.
before clients are denied.
enabled, the AP blocks communication between wireless stations.
radio configuration
show wireless rates {a | b | g | prime-a | prime-g | turbo-a |
turbo-g}
Privileged EXEC
Indicates the physical layer technology to use on the radio.
Indicates data rates valid for the physical mode.
command.