Show Captive-Portal Status; Captive Portal Configuration Commands; Configuration (Captive Portal); Enable (Captive Portal) - D-Link DWL-8500AP Command Reference Manual

CLI Command Reference
Disable Reason If CP is disabled, this field displays the reason, which can be None, Admin-
Captive Portal IP Address Shows the IP address that the captive portal feature uses.

show captive-portal status

This command reports status of all captive portal instances in the system.
Format
Mode
Authenticated Users Shows the number of users currently authenticated to all captive portal
System Supported Users Shows the number of authenticated users that the system can sup-
Configured Captive Portals Shows the number of captive portals configured on the switch.
Supported Captive Portals Shows the number of supported captive portals in the system.
Active Captive Portals. Shows the number of captive portal instances that are operationally

Captive Portal Configuration Commands

The commands in this section are related to captive portal configurations.

configuration (Captive Portal)

Use this command to enter the Captive Portal Instance Mode.
The captive portal configuration, identified by CP ID 1, is the default CP configuration. You
can create up to nine additional captive portal configurations. The system supports a total of
ten CP configurations. The
Format
Mode
no configuration
This command deletes a captive portal configuration. The command fails if interfaces are
associated to this configuration. The default captive portal configuration can not be deleted.
Format
Mode

enable (Captive Portal)

This command enables a captive portal configuration.
Default
206 © 2001- 2008 D-Link Corporation/D-Link Systems, Inc. All Rights Reserved.
istratively Disabled, No IPv4 Address, or Routing Enabled, But no IPv4 rout-
ing interface.
show captive-portal status
Privileged EXEC
instances on this switch.
port.
enabled.
variable is a number in the range of 1-10.
<cp-id>
configuration <cp-id>
Captive Portal Config Mode
no configuration <cp-id>
Captive Portal Config Mode
Enable