Ip Access-Group; Acl-Trapflags; Show Ip Access-Lists - D-Link DWL-8500AP Command Reference Manual

Format
Mode

ip access-group

This command attaches a specified IP ACL to one interface or to all interfaces.
An optional sequence number may be specified to indicate the order of this IP access list
relative to other IP access lists already assigned to this interface and direction. A lower number
indicates higher precedence order. If a sequence number is already in use for this interface and
direction, the specified access list replaces the currently attached IP access list using that
sequence number. If the sequence number is not specified for this command, a sequence
number that is one greater than the highest sequence number currently in use for this interface
and direction is used.
Default
Format
Modes
no ip access-group
This command removes a specified IP ACL from an interface.
Default
Format
Mode

acl-trapflags

This command enables the ACL trap mode.
Default
Format
Mode
no acl-trapflags
This command disables the ACL trap mode.
Format
Mode

show ip access-lists

This command displays an IP ACL
ACL.
Format
Mode
no access-list <accesslistnumber>
Global Config
none
ip access-group <accesslistnumber> in [sequence <1-4294967295>]
Interface Config
Global Config
none
no ip access-group <accesslistnumber> in
Interface Config
disabled
acl-trapflags
Global Config
no acl-trapflags
Global Config
<accesslistnumber>
show ip access-lists <accesslistnumber>
Privileged EXEC
5 Quality of Service (QoS) Commands
is the number used to identify the IP
IP Access Control List (ACL) Commands 251