Gmrp Commands; Set Gmrp Adminmode - D-Link DWL-8500AP Command Reference Manual

CLI Command Reference
Modes
Interface
Join Timer
Leave Timer
LeaveAll Timer This Leave All Time controls how frequently LeaveAll PDUs are gener-
Port GMRP Mode The GMRP administrative mode for the port, which is enabled or dis-

GMRP Commands

This section describes the commands you use to configure and view GARP Multicast
Registration Protocol (GMRP) information. Like IGMP snooping, GMRP helps control the
flooding of multicast packets.GMRP-enabled switches dynamically register and de-register
group membership information with the MAC networking devices attached to the same
segment. GMRP also allows group membership information to propagate across all
networking devices in the bridged LAN that support Extended Filtering Services.
NOTE:

set gmrp adminmode

This command enables GARP Multicast Registration Protocol (GMRP) on the system.
Default
Format
Mode
70 © 2001- 2008 D-Link Corporation/D-Link Systems, Inc. All Rights Reserved.
Privileged EXEC
User EXEC
Valid slot and port number separated by forward slashes.
The interval between the transmission of GARP PDUs registering (or re-reg-
istering) membership for an attribute. Current attributes are a VLAN or multi-
cast group. There is an instance of this timer on a per-Port, per-GARP
participant basis. Permissible values are 10 to 100 centiseconds (0.1 to 1.0
seconds). The factory default is 20 centiseconds (0.2 seconds). The finest
granularity of specification is one centisecond (0.01 seconds).
The period of time to wait after receiving an unregister request for an attribute
before deleting the attribute. Current attributes are a VLAN or multicast
group. This may be considered a buffer time for another station to assert regis-
tration for the same attribute in order to maintain uninterrupted service. There
is an instance of this timer on a per-Port, per-GARP participant basis. Permis-
sible values are 20 to 600 centiseconds (0.2 to 6.0 seconds). The factory
default is 60 centiseconds (0.6 seconds).
ated. A LeaveAll PDU indicates that all registrations will shortly be deregis-
tered. Participants will need to rejoin in order to maintain registration. There
is an instance of this timer on a per-Port, per-GARP participant basis. The
Leave All Period Timer is set to a random value in the range of LeaveAllTime
to 1.5*LeaveAllTime. Permissible values are 200 to 6000 centiseconds (2 to
60 seconds). The factory default is 1000 centiseconds (10 seconds).
abled (default). If this parameter is disabled, Join Time, Leave Time and
Leave All Time have no effect.
If GMRP is disabled, the system does not forward GMRP messages.
disabled
set gmrp adminmode
Privileged EXEC