Mac Access-List Extended Rename; Deny | Permit; Table 9. Ethertype Keyword And 4-Digit Hexadecimal Value - D-Link DWL-8500AP Command Reference Manual

Dws-3000 series/ unified wired & wireless access system
Hide thumbs Also See for DWL-8500AP:
Table of Contents

Advertisement

mac access-list extended rename

This command changes the name of a MAC Access Control List (ACL). The
parameter is the name of an existing MAC ACL. The
alphanumeric string from 1 to 31 characters uniquely identifying the MAC access list.
This command fails if a MAC ACL by the name
Format
Mode

{deny | permit}

This command creates a new rule for the current MAC access list. Each rule is appended to the
list of configured rules for the list.
The 'no' form of this command is not supported, since the rules within a MAC
NOTE:
ACL cannot be deleted individually. Rather, the entire MAC ACL must be
deleted and re-specified.
An implicit 'deny all' MAC rule always terminates the access list.
NOTE:
For assign-queue, attributes are configurable for a deny rule, but they have no
NOTE:
operational effect.
A rule may either deny or permit traffic according to the specified classification fields. At a
minimum, the source and destination MAC value must be specified, each of which may be
substituted using the keyword any to indicate a match on any value in that field. The remaining
command parameters are all optional, but the most frequently used parameters appear in the
same relative order as shown in the command format.
The Ethertype may be specified as either a keyword or a four-digit hexadecimal value from
0x0600-0xFFFF. The currently supported
ipv4, ipx, mplsmcast, mplsucast, netbios, novell, pppoe, rarp. Each of these translates into its
equivalent Ethertype value(s).

Table 9. Ethertype Keyword and 4-digit Hexadecimal Value

Ethertype Keyword
appletalk
arp
ibmsna
ipv4
ipx
mplsmcast
mplsucast
netbios
novell
pppoe
rarp
mac access-list extended rename <name> <newname>
Global Config
0x809B
0x0806
0x80D5
0x0800
0x8037
0x8848
0x8847
0x8191
0x8137, 0x8138
0x8863, 0x8864
0x8035
5 Quality of Service (QoS) Commands
parameter is a case-sensitive
<newname>
already exists.
<newname>
values are: appletalk, arp, ibmsna,
<ethertypekey>
Corresponding Value
MAC Access Control List (ACL) Commands
<name>
247

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dwl-3500ap

Table of Contents