Lldp Receive; Lldp Timers; Lldp Transmit-Tlv - D-Link DWL-8500AP Command Reference Manual

CLI Command Reference
Format
Mode

lldp receive

Use this command to enable the LLDP receive capability.
Default
Format
Mode
no lldp receive
Use this command to return the reception of LLDPDUs to the default value.
Format
Mode

lldp timers

Use this command to set the timing parameters for local data transmission on ports enabled for
LLDP. The
transmitting local data LLDPDUs. The range is 1-32768 seconds. The
multiplier on the transmit interval that sets the TTL in local data LLDPDUs. The multiplier
range is 2-10. The
seconds.
Default
Format
Mode
no lldp timers
Use this command to return any or all timing parameters for local data transmission on ports
enabled for LLDP to the default values.
Format
Mode

lldp transmit-tlv

Use this command to specify which optional type length values (TLVs) in the 802.1AB basic
management set are transmitted in the LLDPDUs. Use
TLV. To configure the system name, see See
transmit the system description TLV. Use
106 © 2001- 2008 D-Link Corporation/D-Link Systems, Inc. All Rights Reserved.
no lldp transmit
Interface Config
disabled
lldp receive
Interface Configuration
lldp receive
Interface Configuration
determines the number of seconds to wait between
<interval-seconds>
<reinit-seconds>
interval—30 seconds
hold—4
reinit—2 seconds
lldp timers [interval <interval-seconds>] [hold <hold-value>]
[reinit <reinit-seconds>
Global Config
no lldp timers [interval] [hold] [reinit]
Global Config
is the delay before re-initialization, and the range is 1-0
]
sys-name
"snmp-server" on page 310. Use
to transmit the system capabilities TLV.
sys-cap
is the
<hold-value>
to transmit the system name
to
sys-desc