Table 5: Default Network Qos Policy (Type = Ip-Interface) To Fc Mapping - Alcatel-Lucent 7210 SAS-R6 OS Quality Of Service Manual

For network ingress,
profile state for the default network QoS policy.

Table 5: Default Network QoS Policy (type = ip-interface) to FC Mapping

"port" Type Network QoS Policy
Network QoS policy of type port defines ingress forwarding class meters and maps traffic to those
meters for only IP traffic received on network and hybrid ports. When a network policy of this
type is created it has a single unicast meter which cannot be deleted. These meters exist within the
definition of the policy. The meters get instantiated in hardware, only when the policy is applied to
a network port. It also defines the forwarding class to DSCP and/or Dot1p marking to be used for
packets sent out through that port.
A network QoS policy of type port defines both the ingress and egress handling of QoS on the
network port.
The following functions are defined:
•
•
7210 SAS-X and 7210 SAS-R6 OS Quality of Service Guide
Table 5 lists the default mapping of EXP values to forwarding class and
Value 7210 FC Ingress
0
1
2
3
4
5
6
7
Ingress
→ Defines DSCP or Dot1p value mapping to forwarding classes. Only one type
supported, such as DSCP or Dot1p, per policy. Option to use DEI bit along with
Dot1p classification.
→ Defines forwarding class to meter mapping.
Egress
→ Specifies remark policy that defines forwarding class to DSCP or Dot1p (or both)
value markings.
Profile
be
l2
af
af
h2
ef
h1
nc
QoS Policies
Out
In
Out
In
In
In
In
In
Page 25