Table of Contents
Advertisement
•
Sample configuration:
*7210-SAS>config>qos# sap-ingress 1 create // Default policy
*7210-SAS>config>qos>sap-ingress$ info
----------------------------------------------
num-qos-classifiers 2
meter 1 create
exit
----------------------------------------------
*7210-SAS>config>qos>sap-ingress$
The following describes the usage of meters when meter in a VPLS service "11" is not configured
in the policy:
•
•
•
•
•
•
The following describes the usage of meters when meter in a VPLS service "11" is defined in the
policy:
•
•
•
7210 SAS-X and 7210 SAS-R6 OS Quality of Service Guide
In the default policy, only meter "1" is defined. All FC and all traffic types use meter "1"
by default. Meter "11" is not created by default and is not available for use.
If a FC is created without explicit meters, the default meter "1" is used for unicast traffic
and for multipoint traffic types (such as broadcast, multicast and unknown-unicast traffic).
If a FC is created with an explicit unicast meter, that meter is used for unicast traffic and
for multipoint traffic types (such as broadcast, multicast and unknown-unicast traffic).
If a FC is created with an explicit unicast meter and explicit broadcast meter, use these
meters for unicast and broadcast traffic respectively and use the unicast meter for all other
traffic types.
If a FC is created with an explicit unicast meter and explicit multicast meter, use the
unicast meter for unicast traffic and multicast meter for all other traffic types.
If a FC is created with an explicit unicast meter, an explicit broadcast meter, and an
explicit multicast meter, use these meters for unicast, broadcast and multicast traffic types
respectively. Unknown unicast traffic type will use the explicitly defined multicast meter.
If a FC is created with an explicit unicast meter, an explicit broadcast meter, an explicit
unknown-unicast meter, and an explicit multicast meter, use these meters for unicast,
broadcast, unknown-unicast and multicast traffic types respectively.
If a FC is created without explicit meters, use the default meter "1" for unicast traffic and
default meter "11" for all other traffic types (such as broadcast, multicast and unknown-
unicast).
If a FC is created with an explicit unicast meter, use that meter for unicast traffic and use
default meter "11" for all other traffic types.
If a FC is created with an explicit unicast meter and explicit broadcast meter, use these
meters for unicast and broadcast traffic respectively and use meter "11" for all other traffic
types.
Service Ingress QoS Policies
Page 205
Advertisement
Table of Contents
