Table of Contents
Advertisement
addition, when executing the no form of the rate command for a queue configured at cir-level 8,
the default CIR (and PIR) value is set 1. Please read the cir-level description under port-parent CLI
command description for more information about the scheduler behavior for queues configured
with cir-level value of 8.
The no form of the command returns all queues created with the queue-id by association with the
QoS policy to the default PIR and CIR parameters (100, 0). (Except for the queue in cir-level 8, in
which "no rate" sets cir=pir=1.)
If queue has cir-level as 8 then CIR should be equal to PIR for the queue, that is for queue with cir-
level 8 all the traffic is considered as CIR(guaranteed).
cir percent — Defines the percentage of the guaranteed rate allowed for the queue. When the rate
Parameters
command is executed, . When the rate command has not been executed, the default is assumed.
Fractional values are not allowed and must be given as a positive integer.
The actual rate is dependent on the queue's adaptation-rule parameters and the actual hardware where
the queue is provisioned.
Values
Default
pir percent — Defines the percentage of the maximum rate allowed for the queue. When the rate command
is executed, the PIR setting is optional. When the rate command has not been executed, or the PIR
parameter is not explicitly specified, the default PIR of 100 is assumed. Fractional values are not
allowed and must be given as a positive integer.
Values
Default
7210 SAS-X and 7210 SAS-R6 OS Quality of Service Guide
0 — 100
0
1— 100 percent
100
Operational Commands
Page 191
Advertisement
Table of Contents
