Table of Contents
Advertisement
Basic Configurations
FCef = 0 + 0 + 0 + 0 = 0
FCh2 = 1 + 0 + 1 + 0 = 2
FCl1 = 1 + 0 + 1 + 0 = 2
Since this FC uses unicast meter and multicast meter, an entry is needed to identify these traffic
types explicitly. Broadcast and unknown-unicast traffic is also classified using the same entry as
multicast and use the same meter.
FCaf = 1 + 0 + 1 + 0 = 2
Since this FC uses unicast meter, an entry is needed to identify these traffic types explicitly.
Another entry is needed to classify broadcast, multicast and unknown-unicast traffic type to the
same FC and use the default meter #11.
FCl2 = 0 + 0 + 0 + 0 = 0
FCbe = 1 + 0 + 1 + 0 = 2
Using the above equation, the total classification entries used = 8 and meters used = 4.
If the same policy were to be used for a SAP in an Epipe service, then since all traffic is classified
to a unicast traffic type and since only unicast meters are used, the following:
FCnc = 0 + 0 + 0 + 0 = 0
FCh1 = 0 + 0 + 0 + 0 = 0
FCef = 0 + 0 + 0 + 0 = 0
FCh2 = 1 + 0 + 0 + 0 = 1
FCl1 = 1 + 0 + 0 + 0 = 1
FCaf = 1 + 0 + 0 + 0 = 1
FCl2 = 0 + 0 + 0 + 0 = 0
FCbe = 1 + 0 + 0 + 0 = 1
Using the above equation, the total classification entries used = 4 and meters used = 2.
Example 7
sap-ingress 10 create
num-qos-classifiers 8
meter 1 create
exit
meter 11 multipoint create
exit
meter 3 create
exit
meter 4 create
exit
fc be create
exit
fc af create
exit
default-fc be
match entry 1
Page 244
7210 SAS-X and 7210 SAS-R6 OS Quality of Service Guide
meter 1
broadcast-meter 11
mulitcast-meter
4
meter 3
Advertisement
Table of Contents
