Table of Contents
Advertisement
explicit.
NOTE: Before associating a SAP ingress policy configured to use IPv6 criteria with a SAP, resources must
be allocated using the CLI command config> system> resource-profile>ingress-internal-tcam> qos-sap-
ingress-resource> ipv6-ipv4-match-enable. Please read the 7210 Basic Systems Guide for more information
about this CLI command and resource allocation.
The no form of this command deletes all the entries specified under this node. Once ipv6-criteria entries are
removed from a SAP ingress policy, the ipv6-criteria is removed from all services where that policy is
applied.
Parameters
any — -Specifies that entries can use any of the fields available under ipv6-criteria (Example - IPv6 source,
IPv6 destination, IPv6 protocol fields can be used) for matching
dscp-only — Specifies that entries can use the IP DSCP field or IPv6 precedence field.
policy-id — -The policy-id that uniquely identifies the policy.
Values
mac-criteria
Syntax
[no] mac-criteria [any|dot1p-only] policy id
Context
config>qos>sap-ingress
Description
The mac-criteria based SAP ingress policies are used to select the appropriate ingress meters and
corresponding forwarding class for matched traffic.
User can specify either 'any' or dot1p-only' as the sub-criteria. The sub-criteria determines what fields can be
used to match traffic. The resource allocation for classification is affected by the sub-criteria in use. Please
see the section on SAP ingress resource allocation for L2 and L3 criteria for more information.
This command is used to enter the node to create or edit policy entries that specify MAC criteria.
7210 SAS OS implementation will exit on the first match found and execute the actions in accordance with
the accompanying action command. For this reason entries must be sequenced correctly from most to least
explicit.
The no form of this command deletes all the entries specified under this node. Once mac-criteria entries are
removed from a SAP ingress policy, the mac-criteria is removed from all services where that policy is
applied.
Default
any
Parameters
any — .Specifies that entries can use any of the fields available under mac-criteria (Example - MAC
source, MAC destination, MAC Ethertype, etc. fields can be used)
dot1p-only — Specifies that entries can use only the Dot1p field.
policy-id — -The policy-id that uniquely identifies the policy.
Values
7210 SAS-X and 7210 SAS-R6 OS Quality of Service Guide
1 — 65535
1 — 65535
Operational Commands
Page 281
Advertisement
Table of Contents
