Table of Contents
Advertisement
Service Ingress QoS Policy Forwarding Class Commands
multicast-meter
Syntax
multicast-meter meter-id
no multicast-meter
Context
config>qos>sap-ingress>fc
Context
This command overrides the default multicast forwarding type meter mapping for fc fc-name. The specified
meter -id must exist within the policy as a multipoint meter before the mapping can be made. Once the
forwarding class mapping is executed, all multicast traffic on a SAP using this policy is forwarded using the
meter-id.
The multicast forwarding type includes the unknown unicast forwarding type and the broadcast forwarding
type unless each is explicitly defined to a different multipoint meter. When the unknown and broadcast
forwarding types are left as default, they will track the defined meter for the multicast forwarding type.
The no form of the command sets the multicast forwarding type meter-id back to the default meter for the
forwarding class. If the broadcast and unknown forwarding types were not explicitly defined to a
multipoint meter, they will also be set back to the default multipoint meter (11).
Parameters
meter-id — Specifies an existing multipoint queue defined in the config>qos>sap-ingress context.
Values
Default
queue
Syntax
[no] queue queue-id
Context
config>qos>sap-ingress>fc
Description
This command overrides the default unicast forwarding type queue mapping for fc fc-name. The specified
queue-id must exist within the policy as a non-multipoint queue before the mapping can be made. Once the
forwarding class mapping is executed, all unicast traffic (this includes all traffic, even broadcast and
multicast for services) on a SAP using this policy is forwarded using the queue-id.
The no form of this command sets the unicast (point-to-point) queue-id back to the default queue for the
forwarding class (queue 1).
NOTE: SAP ingress queuing is supported only on 7210 SAS-X. It is not supported on 7210 SAS-R6
Parameters
queue-id — Specifies an existing non-multipoint queue defined in the config>qos>sap-ingress context.
Values Any valid non-multipoint queue-id in the policy including 1 and 3 through 32.
Default
1
Page 284
7210 SAS-X and 7210 SAS-R6 OS Quality of Service Guide
1— 32
11
Advertisement
Table of Contents
