Table of Contents
Advertisement
Network Ingress QoS Policy Commands
Default
rate 0 pir max — The max default specifies the amount of bandwidth in kilobits per second
(thousand bits per second). The max value is mutually exclusive to the pir-rate value.
Parameters
cir cir-rate-in-kbps — The cir parameter overrides the default administrative CIR used by the meter. When
the rate command has not been executed or the cir parameter is not explicitly specified, the default CIR
(0) is assumed.
Values
pir pir-rate-in-kbps — Defines the administrative PIR rate, in kilobits, for the meter. When this rate
command is executed, the PIR setting is optional.When the rate command has not been executed, the
default PIR of max is assumed.
Fractional values are not allowed and must be given as a positive integer.
The actual PIR rate is dependent on the meter's adaptation-rule parameters and the actual hardware
where the meter is provisioned.
Values
mpls-lsp-exp-profile
Syntax
mpls-lsp-exp-profile policy-id [create ]
no mpls-lsp-exp-profile
Context
config>qos>network>ingress
Description
Specify the mpls-lsp-exp-profile-map policy to use for assigning profile values for packets
received on this IP interface.
When 'no ldp-use-local-fc-enable' is set, this policy is managed by the system. User is not allowed
to modify it. The system assigns the same policy ID as the network policy ID. It is cannot be
modified by the user.
When 'ldp-use-local-fc-enable' is set, by default the system assigns the default policy ID "1". User
can create new policies and specify the new policy instead of the default policy.
Note: For LDP LSP traffic, the system always uses the global mpls-lsp-exp-profile-map policy.
For RSVP LSP traffic, system uses the mpls-lsp-exp-profile-map policy associated with the
network policy. It is highly recommended to use a single mpls-lsp-exp-profile-map policy for all
the network policies when FRR facility is in use for consistent QoS treatment.
Parameters
policy-id — The policy-id uniquely identifies the policy on the 7210 SAS.
Values
Page 148
7210 SAS-X and 7210 SAS-R6 OS Quality of Service Guide
0 — 20000000, max
0 — 20000000, max
1 — 65535
Advertisement
Table of Contents
