Table of Contents
Advertisement
Network Egress QoS Policy Commands
egress
Syntax
egress
Context
config>qos>network policy-id
Description
This command is used to enter the CLI node that creates or edits egress policy entries that specify
the forwarding class Dot1p marking map to be instantiated when this policy is applied to the
network port.
The forwarding class and profile state mapping to EXP bits mapping for all packets are defined in
this context.
All out-of-profile service packets are marked with the corresponding out-of-profile EXP bit value
at network egress. All the in-profile service ingress packets are marked with the corresponding in-
profile EXP bit value based on the forwarding class they belong.
fc
Syntax
[no] fc fc-name
Context
config>qos>network>egress
Description
This command specifies the forwarding class name. The forwarding class name represents an
egress queue. The fc fc-name represents a CLI parent node that contains sub-commands or
parameters describing the egress characteristics of the queue and the marking criteria of packets
flowing through it. The fc command overrides the default parameters for that forwarding class to
the values defined in the network default policy. Appropriate default parameters are picked up
based on whether the network-policy-type is port or ip-interface.
The no form of this command removes the forwarding class LSP EXP/Dot1p/DSCP associated
with this , as appropriate. The forwarding class reverts to the defined parameters in the default
network policy. If the fc-name is removed from the network policy that forwarding class reverts to
the factory defaults.
Default
Undefined forwarding classes default to the configured parameters in the default network policy
policy-id 1.
7210 SAS-X and 7210 SAS-R6 OS Quality of Service Guide
Operational Commands
Page 149
Advertisement
Table of Contents
