Alcatel-Lucent 7210 SAS-R6 OS Quality Of Service Manual page 144

Network Ingress QoS Policy Commands
Table 32: Default Class Selector Code Points to DSCP Value Mapping Table (Continued)
DSCP Name
cs3
cs2
cs1
fc fc-name — Enter this required parameter to specify the fc-name with which the code point will be
associated.
Default
Values
profile {in | out} — Enter this required parameter to indicate whether the DiffServ code point value is the
in-profile or out-of-profile value.
NOTE 1: DSCP values mapping to forwarding classes Expedited (ef), High-1 (h1) and Network-
Control (nc) can only be set to in-profile.
NOTE 2: DSCP values mapping to forwarding class 'be' can only be set to out-of-profile.
Default
Values
lsp-exp
Syntax lsp-exp lsp-exp-value fc fc-name
no lsp-exp lsp-exp-value
Context config>qos>network policy-id>ingress
Description
This command creates a mapping between the LSP EXP bits of the network ingress traffic and the
forwarding class.
Ingress traffic that matches the specified LSP EXP bits will be assigned to the corresponding
forwarding class. Multiple commands can be entered to define the association of some or all eight
LSP EXP bit values to the forwarding class. For undefined values, packets are assigned to the
forwarding class specified under the default-action command.
The no form of this command removes the association of the LSP EXP bit value to the forwarding
class. The default-action then applies to that LSP EXP bit pattern.
Default
none
Page 144 7210 SAS-X and 7210 SAS-R6 OS Quality of Service Guide
DSCP Value
Decimal
24
16
08
none, for every DSCP value defined, the forwarding class must be indicated.
be, l2, af, l1, h2, ef, h1, nc
None, for every DSCP value defined, the profile must be indicated. If a DSCP value is not
mapped, the default-action forwarding class and profile state will be used for that value.
in, out
DSCP Value
Hexadecimal
0x18 0b011000
0x10 0b010000
0x8 0b001000
DSCP Value
Binary