Table of Contents
Advertisement
Only remark policy of type dot1p or dot1p-lsp-exp-shared or dscp or dot1p-dscp is allowed for use
with access-egress policy.
Parameters
policy-id — The value that uniquely identifies the remark policy.
Values
remarking
Syntax
[no] remarking
remarking
Context
config>qos>access-egress
config>qos>network>egress
Description
This command enables the system to remark egress packets sent out of access ports, network ports
and hybrid ports.
When remarking is enabled, the remark policy configured is used to determine the FC to QoS bit
(For example: Dot1p or DSCP or EXP, based on the remark policy configured and egress packet
encapsulation) mapping. Please refer to the remark policy supported for different service entities
in the chapter on remark policies.
The no form of the command disables remarking.
Default
no remarking -
scope
Syntax
scope {exclusive | template}
no scope
Context
config>qos>access-egress
Description
This command configures the scope as exclusive or template. The policy's scope cannot be
changed if the policy is applied to multiple ports.
The no form of this command sets the scope of the policy to the default of template.
Default
template
Parameters
exclusive — When the scope of a policy is defined as exclusive, the policy can only be applied to one port.
If a policy with an exclusive scope is assigned to a second interface an error message is generated. If the
policy is removed from the exclusive interface, it will become available for assignment to another
7210 SAS-X and 7210 SAS-R6 OS Quality of Service Guide
1 — 655353
Remarking is disabled by default
Page 323
Advertisement
Table of Contents
