Table of Contents
Advertisement
action defined. The profile assigned by the user is used subsequently to determine the slope to use at the
ingress and egress queuing points and is used for egress marking (if enabled).
in — The in parameter is mutually excusive to the out parameter following the profile classification action
keyword. Either in or out must be specified when the profile keyword is present. When in is specified,
any packets matching the classification rule will be treated as in-profile.
out — The out parameter is mutually excusive to the in parameter following the profile classification action
keyword. Either in or out must be specified when the profile keyword is present. When out is specified,
any packets matching the classification rule will be treated as out-of-profile.
use-dei — Specifies whether DEI must be used to determine the initial profile of the packet.
fc
Syntax
[no] fc fc-name [create]
Context
config>qos>sap-ingress
Description
The fc command creates a class instance of the forwarding class fc-name. Once the fc-name is created,
classification actions can be applied and can be used in match classification criteria.
The no form of the command removes all the explicit queue mappings for fc-name forwarding types. The
queue mappings revert to the default meters for fc-name.
Parameters
fc-name — Specifies the forwarding class name for the queue. The value given for the fc-name must be one
of the predefined forwarding classes for the system.
Values
Default
ip-mac-match
Syntax
[no] ip-mac-match {ip-first | mac-first}
Context
config>qos>sap-ingress
Description
This command must be executed if user intends to match on both IP and MAC criteria in a SAP ingress
policy. It this command is not executed software does not allow for configuration of both IP and MAC
criteria in a SAP ingress policy. In other words, without this command in a SAP ingress policy IP and MAC
criteria are mutually exclusive.
User also has the option to specify if all the IP criteria entries configured in the policy need to be matched
first followed by all the MAC criteria entries or viceversa. In other words, if ip-first is configured all the IP
criteria entries are matched and only if there are no matches in the MAC criteria entries are matched. If a
match is found no further matches are done and the actions associated with the matched entry are taken.
Default
no ip-mac-match
7210 SAS-X and 7210 SAS-R6 OS Quality of Service Guide
fc:
class
None (Each class-name must be explicitly defined)
class: be, l2, af, l1, h2, ef, h1, nc
Operational Commands
Page 279
Advertisement
Table of Contents
