Alcatel-Lucent 7210 SAS-R6 OS Quality Of Service Manual page 393

Remark Policy QoS Commands
remark
Syntax [no] remark policy-id remark-type {dot1p | dscp | lsp-exp | dot1p- lsp-exp-shared | dot1p-dscp}
create
Context config>qos
Description This command creates a new remark policy of the specified type. The 7210 SAS allows the
sharing of this policy between different service entities to optimize the hardware resources used.
The following types of remark policies are available:
•
•
•
•
•
The device uses a common pool of hardware resources to mark dot1p values for SAP egress
marking and lsp-exp values for network IP interface. Remark policies of type dot1p-lsp-exp-
shared allow the user to define a single policy, the system allocates a single hardware resource and
this policy can be used for multiple SAP egress marking or network IP interfaces. The users can
define a single policy of type dot1p or lsp-exp and use it with multiple SAP egress marking and
network IP interfaces respectively.
The 'remark-type' of the policy also determines the values user is allowed to configure in the
policy. For example, if remark-type is dot1p, user is allowed to only specify the forwarding class
to dot1p values.
Default
dot1p-lsp-exp-shared
Parameters policy-id —
Values
remark-type —
Values
7210 SAS-X and 7210 SAS-R6 OS Quality of Service Guide
dot1p (Used for SAP egress markingand network qos [port type] policies)
dscp (Used for network qos [port type] policies)
lsp-exp (Used for network qos [ip-interface type] policies)
dot1p-lsp-exp-shared (Used for SAP egress marking and network qos [ip-interface type]
policies)
dot1p-dscp ( Used for network qos [port type] policies).
The policy ID of the remark policy.
Valid names consist of any string up to 32 characters long composed of printable, 7-bit
ASCII characters. If the string contains special characters (#, $, spaces, etc.), the entire
string must be enclosed within double quotes.
Specifies the type of marking values in the remark policy.
dot1p — Specifies FC to 802.1 Dot1p value.
lsp-exp— Specifies FC to MPLS LSP EXP values
dot1p-lsp-exp-shared— Specifies FC to both 802.1 Dot1p and MPLS LSP EXP values.
Page 393