Table of Contents
Advertisement
Network Egress QoS Policy Forwarding Class Commands
fc
Syntax
[no] fc fc-name [create]
Context
config>qos>network>ingress
config>qos>remark
Description
This command creates a class instance of the forwarding class. Once the fc-name is created,
classification actions can be applied and it can be used in match classification criteria.
The no form of the command removes all the explicit meter mappings for fc-name forwarding
types. The meter mappings revert to the default meters for fc-name.
Default
Undefined forwarding classes default to the configured parameters in the default policy policy-id
1.
Parameters
fc-name — The case-sensitive, system-defined forwarding class name for which policy entries will be
created.
Values
create — The keyword used to create the forwarding class. The create keyword requirement can be
enabled/disabled in the environment>create context.
remark
Syntax
[no] remark policy-id
[no] remark policy-id [create] [remark-type remarking type]
Context
config>qos>network policy-id>egress
config>qos
Description
Allows the user to configure the remark policy to use marking the DSCP and Dot1p (802.1p)
values in the packet header for IP packets sent out of this port. User should execute 'remarking'
CLI command. If user enables remarking, without specifying a remark policy the system uses a
default policy of remark-type 'dscp-only'
Note: For an IP- Interface based policy, the remark policy type can be lsp-exp-only or dot1p-lsp-
exp-shared.
Note: For port based policy the remark policy can be dot1p-dscp.
Default
dscp-only
7210 SAS-X and 7210 SAS-R6 OS Quality of Service Guide
be, l2, af, l1, h2, ef, h1, nc
Operational Commands
Page 151
Advertisement
Table of Contents
