Table of Contents
Advertisement
IP QoS Policy Match Commands
ip-prec
Syntax
ip-prec ip-prec-value [ip-prec-mask]
no ip-prec
Context
config>qos>sap-ingress>ip-criteria>entry>match
config>qos>sap-ingress>ipv6-criteria>entry>match
Description
This command defines a specific IP Precedence value that must be matched to perform the associated
classification actions. If an ingress packet on the SAP where the SAP ingress QoS policy is applied to
matches the specified IP Precedence value, the actions associated with this entry are taken.
The ip-prec-value is derived from the most significant three bits in the IP header ToS byte field (precedence
bits). The three precedence bits define 8 Class-of-Service (CoS) values commonly used to map packets to
per-hop Quality-of-Service (QoS) behavior. The precedence bits are also part of the newer DiffServ Code
Point (DSCP) method of mapping packets to QoS behavior. The DSCP uses the most significant six bits in
the IP header ToS byte and so overlaps with the precedence bits.
Both IP precedence and DSCP classification rules are supported. A match entry cannot match on both IP
DSCP and IP precedence values. In other words, user can use either IP DSCP or IP precedence match in a
match entry but not both. The software blocks configuration of ip-precedence match if ip-dscp is configured
already. The converse is also true. A single policy having multiple match entries can have entries such that
some of them match IP DSCP and some others match IP precedence. The order of the entry determines the
priority of the match.
The no form of the command removes the IP Precedence match criterion.
Parameters
ip-prec-value — The ip-prec-value is a required parameter that specifies the unique IP header ToS byte
precedence bits value that will match the IP precedence rule.
Values
mask — The mask to use for the match.
src-ip
Syntax
src-ip {ip-address/mask | ip-address netmask}
no src-ip
Context
config>qos>sap-ingress>ip-criteria>entry>match
config>qos>sap-egress>ip-criteria>entry>match
config>qos>sap-ingress>ipv6-criteria>entry>match
Description
This command configures a source IP or IPv6 address range to be used as an SAP QoS policy match
criterion.
To match on the source IP or IPv6 address, specify the address and its associated mask, e.g. 10.1.0.0/16. The
conventional notation of 10.1.0.0 255.255.0.0 can also be used.
The no form of the command removes the source IP or IPv6 address match criterion.
Default
No source IP match criterion.
Page 292
7210 SAS-X and 7210 SAS-R6 OS Quality of Service Guide
0 — 7
Advertisement
Table of Contents
