Table of Contents
Advertisement
Parameters
lsp-exp-value — Specify the LSP EXP values to be associated with the forwarding class.
Default
Values
fc fc-name — Enter this required parameter to specify the fc-name that the EXP bit pattern will be
associated with.
Default
Values
adaptation-rule
Syntax
adaptation-rule [cir adaptation-rule] [pir adaptation-rule]
no adaptation-rule
Context
config>qos>network>ingress>meter
Description
This command defines the method used by the system to derive the operational CIR and PIR
settings when the meter is provisioned in hardware. For the CIR and PIR parameters, individually
the system attempts to find the best operational rate depending on the defined constraint.
The no form of the command removes any explicitly defined constraints used to derive the
operational CIR and PIR created by the application of the policy. When a specific adaptation-rule
is removed, the default constraints for rate and cir apply.
Default
adaptation-rule cir closest pir closest
Parameters
adaptation-rule — Specifies the adaptation rule to be used while computing the operational CIR or PIR
value.
pir — Defines the constraints enforced when adapting the PIR rate defined within the meter meter-id rate
command. The pir parameter requires a qualifier that defines the constraint used when deriving the
operational PIR for the meter. When the rate command is not specified, the default applies.
cir — Defines the constraints enforced when adapting the CIR rate defined within the meter meter-id rate
command. The cir parameter requires a qualifier that defines the constraint used when deriving the
operational CIR for the meter. When the cir parameter is not specified, the default constraint applies.
max — The max (maximum) option is mutually exclusive with the min and closest options. When max is
defined, the operational PIR/CIR will be the next multiple of8 kbps that is equal to or lesser than the
specified rate.
min — The min (minimum) option is mutually exclusive with the max and closest options. When min is
defined, the operational PIR/CIR will be the next multiple of 8 kbps that is equal to or higher than the
specified rate.
closest — The closest parameter is mutually exclusive with the min and max parameter. When closest is
defined, the operational PIR/CIR will be the next multiple of 8 kbps ( that is closest to the specified rate.
7210 SAS-X and 7210 SAS-R6 OS Quality of Service Guide
None, the lsp-exp command must define a value.
0 to 8 (Decimal representation of three EXP bit field)
None, the lsp-exp command must define a fc-name.
be, l2, af, l1, h2, ef, h1, nc
Operational Commands
Page 145
Advertisement
Table of Contents
