Table of Contents
Advertisement
exit
fc
exit
mac-criteria dot1p-only
exit
exit
In the example above, assuming the policy is attached to a SAP in a VPLS service, the
classification entries used per FC are:
FCnc = 0 + 0 + 0 + 0 = 0
FCh1 = 1 + 1 + 1 + 1 = 4
Since this FC uses unicast, broadcast, multicast and unknown-unicast meter, four entries are
needed to identify these traffic types explicitly.
FCef = 0 + 0 + 0 + 0 = 0
FCh2 = 1 + 1 + 1 + 0 = 3
Since this FC uses unicast meter and broadcast meter, two entries are needed to identify these
traffic types explicitly. Another entry if needed to classify multicast and unknown-unicast traffic
type to the same FC and use the default meter #11.
FCl1 = 1 + 1 + 1 + 0 = 3
Since this FC uses only unicast meter, an entry is needed to identify this traffic type explicitly.
Another entry is needed to classify broadcast, multicast and unknown-unicast traffic type to the
same FC and use the default meter #11.
FCaf = 1 + 1 + 1 + 0 = 3
7210 SAS-X and 7210 SAS-R6 OS Quality of Service Guide
broadcast-meter 2
h1 create
meter 5
broadcast-meter 4
multicast-meter
4
unknown-meter
4
entry 1 create
match dot1p7
action fc af
exit
entry 2 create
match dot1p 5
action fc l1
exit
entry 3 create
match dot1p6
action fc h2
exit
entry 4 create
match dot1p 3
action fc h1
exit
Service Ingress QoS Policies
Page 231
Advertisement
Table of Contents
