Table of Contents
Advertisement
queue-mgmt
Syntax
[no] queue-mgmt name
Context
config>qos
Description
This command enables the context to configure a QoS queue management policy. A set of profiles/
templates are available in hardware for configuring the queue parameters such as CBS, MBS, and
WRED slopes parameters per queue. These profiles are available for use with multiple queues of
the system. Queue management policy allows the user to define the queue parameters and allow
for sharing among the queues.
Parameters
name —
Values
time-average-factor
Syntax
time-average-factor value
no time-average-factor
Context
config>qos>queue-mgmt
Description
This command is used to configure the time-average factor.
Default
7
Parameters
value — Represents the Time Average Factor (TAF), expressed as a decimal integer. The value specified for
TAF affects the speed at which the shared buffer average utilization tracks the instantaneous shared
buffer utilization. A low value weights the new shared buffer average utilization calculation more to the
shared buffer instantaneous utilization, zero using it exclusively. A high value weights the new shared
buffer average utilization calculation more to the previous shared buffer average utilization value.
Values
scope
Syntax
scope {exclusive | template}
no scope
Context
config>qos>queue-mgmt
Description
This command configures the scope as exclusive or template.
The no form of this command sets the scope of the policy to the default of template.
7210 SAS-X and 7210 SAS-R6 OS Quality of Service Guide
The name of the queue management policy.
Valid names consist of any string up to 32 characters long composed of printable, 7-bit
ASCII characters. If the string contains special characters (#, $, spaces, etc.), the entire
string must be enclosed within double quotes.
0 — 15
Page 375
Advertisement
Table of Contents
