Table of Contents
Advertisement
Network QoS Policy Commands
When ldp-use-local-fc-enable is set, system does not create the mpls-lsp-exp-profile-map policies
by default (except for the default policy "1"). User is allowed to create, delete, modify, copy the
policies. User needs to associate these policies with appropriate network policies as per their
requirement.
Default
1 (default mpls-lsp-exp-profile-map policy "1").
Parameters
policy-id — The policy-id uniquely identifies the policy on the 7210 SAS.
Values
create — The keyword used to create a policy.
lsp-exp
Syntax
lsp-exp lsp-exp-value
no lsp-exp
Context
config>qos> mpls-lsp-exp-profile-map
Description
This command creates a mapping between the LSP EXP bits of the network ingress traffic and the
profile.
Ingress traffic that matches the specified LSP EXP bits will be assigned the corresponding profile.
Multiple commands can be entered to define the association of some or all eight LSP EXP bit
values to the profile. For undefined values, packets are assigned the profile value out.
The no form of this command removes the association of the LSP EXP bit value to the profile
value. The default profile value 'out' then applies to that LSP EXP bit pattern.
Default
none
Parameters
lsp-exp-value — The 3-bit LSP EXP bit value, expressed as a decimal integer.
Values
use-global-mpls-lsp-exp-profile
Syntax
use-global-mpls-lsp-exp-profile policy-id
no use-global-mpls-lsp-exp-profile
Context
config>qos
Description
This command allows the user to associate the mpls-lsp-exp-profile-map policy for use with LDP
LSPs. When color aware metering is in use for the IP interface, the policy specified here provides
the profile to assign to the MPLS packets received on any of the network IP interface in use in the
system. The MPLS EXP bits in the received packet are matched for assigning the profile.
Page 136
7210 SAS-X and 7210 SAS-R6 OS Quality of Service Guide
1— 65535
0 — 7
Advertisement
Table of Contents
