Table of Contents
Advertisement
Basic Configurations
Since this FC uses unicast, broadcast and multicast meter, three entries are needed to identify these
traffic types explicitly. Unknown-unicast traffic type is classified using the same entry as multicast
traffic type and uses the same meter.
FCl2 = 0 + 0 + 0 + 0 = 0
FCbe = 1 + 0 + 1 + 0 = 2
Using the above equation, the total classification entries used = 15 and meters used = 6.
If the same policy were to be used for a SAP in an Epipe service, then since all traffic is classified
to a unicast traffic type and since only unicast meters are used, the following results:
FCnc = 0 + 0 + 0 + 0 = 0
FCh1 = 1 + 0 + 0 + 0 = 1
FCef = 0 + 0 + 0 + 0 = 0
FCh2 = 1 + 0 + 0 + 0 = 1
FCl1 = 1 + 0 + 0 + 0 = 1
FCaf = 1 + 0 + 0 + 0 = 1
FCl2 = 0 + 0 + 0 + 0 = 0
FCbe = 1 + 0 + 0 + 0 = 1
Using the above equation, the total classification entries used = 5 and meters used = 3 (since all
FCs used only meter #1, meter #3 and meter #5).
Example 3a (Default multipoint meter "11" is not used):
sap-ingress 10 create
description
num-qos-classifiers
meter 1 create
exit
meter 3 create
exit
meter
exit
meter 4 create
exit
meter 5 create
exit
scope template
default-fc
fc af
exit
fc l1
exit
fc h2
Page 232
7210 SAS-X and 7210 SAS-R6 OS Quality of Service Guide
"example-policy-2"
12
rate cir 100 pir 100
rate cir 100 pir 100
2 create
rate cir 1 pir 20
rate cir 10 pir 100
rate cir 10 pir 10
be
create
meter
3
broadcast-meter 2
multicast-meter 4
create
meter
3
broadcast-meter 2
create
Advertisement
Table of Contents
