Table of Contents
Advertisement
Basic Configurations
Since this FC uses unicast, broadcast and multicast meter, three entries are needed to identify these
traffic types explicitly. Unknown-unicast traffic type is classified using the same entry as multicast
traffic type and uses the same meter.
FCl2 = 0 + 0 + 0 + 0 = 0
FCbe = 1 + 0 + 0 + 0 = 1
Since no explicit meters are configured for FC be, it uses meter 1 for all traffic types and needs one
entry is needed to identify these traffic types.
Using the above equation, the total classification entries used = 12 and meters used = 5. The num-
qos-classifiers can be set to 12 (the minimum value).
If the same policy were to be used for a SAP in an Epipe service, then since all traffic is classified
to a unicast traffic type and since only unicast meters are used, the following results:
FCnc = 0 + 0 + 0 + 0 = 0
FCh1 = 1 + 0 + 0 + 0 = 1
FCef = 0 + 0 + 0 + 0 = 0
FCh2 = 1 + 0 + 0 + 0 = 1
FCl1 = 1 + 0 + 0 + 0 = 1
FCaf = 1 + 0 + 0 + 0 = 1
FCl2 = 0 + 0 + 0 + 0 = 0
FCbe = 1 + 0 + 0 + 0 = 1
Using the above equation, the total classification entries used = 5 and meters used = 3 (since all
FCs used only meter #1, meter #3 and meter #5). For epipe service a policy with num-qos-
resources set to 6 can be used.
Page 234
7210 SAS-X and 7210 SAS-R6 OS Quality of Service Guide
Advertisement
Table of Contents
