Global Prefix/Suffix - Datalogic QuickScan I QD24 Series Product Reference Manual

Enter/Exit Programming Mode

Global Prefix/Suffix

This option sets up to 20 characters each from the set of ASCII characters or any hex value from 00 to FF. The
characters may be added as a prefix (in a position before the bar code data, also called a header) and/or as a suffix (in
a position following the bar code data, also called a footer). See
this feature.
To configure this feature, scan the ENTER/EXIT PROGRAMMING MODE bar code above to place the unit in
Programming Mode, then the "Set Global Prefix" or "Set Global Suffix," bar code followed by the digits (in hex)
from the Alphanumeric characters in
expected string of 20 characters are selected, scan the ENTER/EXIT bar code to terminate the string. Exit
programming mode by scanning the ENTER/EXIT bar code again.
$CLFSU
Set Global Suffix
Make a mistake? Scan the CANCEL bar code to abort and not
save the entry string. You can then start again at the begin-
ning.
48
Appendix D, Keypad
DEFAULT
Global Suffix = 0x0D (CR)
page 219 for more detailed instructions on setting
representing your desired character(s). If less than the
$CLFPR
Set Global Prefix
~
No Global Prefix
CANCEL
QuickScan™ I QD24XX