Removing And Installing Mounting Bracket - Volkswagen Golf Variant 2007 Workshop Manual

• Receptacle -arrow- for tip -A- of clutch pedal must stand ver‐
tically.
– Insert tip -A- of clutch pedal in bearing recess of over-centre
spring.
– Depress clutch pedal slightly, push bolt through and tighten
self-locking nut to specified torque
Some cars have damping -arrow- on the mounting bracket/clutch
pedal.
– Return it to installation position.
Vehicles without knee airbag
– Install crash bar -1- in front of clutch pedal by screwing on and
tightening nuts -2-.
Vehicles with knee airbag
– Install bracket for knee airbag together with crash bar ⇒ Inte‐
rior equipment; Rep. gr. 69 ; Airbag; Removing and installing
knee airbag bracket .
Continuation for all
– Install driver side footwell cover and driver side left trim panel
⇒ General body repairs, interior; Rep. gr. 68 ; Compartments,
covers and trim panels .
2.4.3 Specified torques
Component
Clutch pedal to mounting bracket
♦ Renew self-locking nuts
Crash bar to steering column mounting
bracket
2.5 Removing and installing mounting
bracket
Special tools and workshop equipment required
Golf Variant 2007 ➤ , Golf Variant 2010 ➤ , Jetta 2005 ➤ , Jetta 2011 ➤
⇒ page 23 .
6-speed manual gearbox 02Q - Edition 06.2010
Nm
25
10
2. Repairing clutch mechanism
23