Volkswagen Golf Variant 2007 Workshop Manual page 147

– Set gearbox housing in place and tighten new bolts -A-, -B-
and -C- to specified torque.
Allocation of bolts:
A - Bolt with captive washer
B - Bolt without washer
C - Bolt with captive washer
– If a washer was laid on the deep groove ball bearing before
the gearbox housing was set in place, a washer -1- (outer di‐
ameter = 78.6 mm) must also be placed above the deep
groove ball bearing -2-
– Install retaining ring -1- for deep groove ball bearing of input
shaft.
– Remove support bridge -30 - 211 A- for input shaft.
– If stop sleeve for selector shaft has been removed, now drive
it in to stop of tool ⇒ page 163
– Turn gearbox in repair stand with opening for selector shaft
upwards.
– Insert selector shaft -1- in lower bearing -2- and in selector
forks -3-.
Note
For better clarity, sealing cover is removed in illustration.
Golf Variant 2007 ➤ , Golf Variant 2010 ➤ , Jetta 2005 ➤ , Jetta 2011 ➤
⇒ page 141 .
.
6-speed manual gearbox 02Q - Edition 06.2010
5. Dismantling and assembling gearbox
143