Removing And Installing Gear Selector Cable And Gate Selector Cable - Volkswagen Golf Variant 2007 Workshop Manual

Golf Variant 2007 ➤ , Golf Variant 2010 ➤ , Jetta 2005 ➤ , Jetta 2011 ➤
6-speed manual gearbox 02Q - Edition 06.2010
• Distance to body must be same on both sides.
Secure selector housing
⇒ Item 16 (page 67) .
– Install cable support bracket on gearbox and tighten bolts to
specified torques ⇒ Item 6 (page 71)
⇒ Item 10 (page 71)
The holes in the cable end-pieces have different diameters.
Allocation of cable end-pieces
– Spread a small quantity of grease -G 000 450 02- on pin
-arrows- of gearbox selector lever -1- and, as needed, relay
lever pin -2-.
– Renew securing clip -3- and, for metal relay lever, securing
clip -4- each time they are removed.
– Secure gear selector cable with securing clip -3- and gate se‐
lector cable with securing clip -4-.
Cable end-piece to plastic relay lever
– Fit relay lever and cable end-piece together
– Insert gate selector cable in cable end-piece.
Continued for all selector mechanisms
– Install centre console securing bracket and centre console ⇒
General body repairs, interior; Rep. gr. 68 ; Compartments,
covers and trims .
– Install gaiter with selector knob and noise insulation
⇒ page 62 .
– Install underbody panels ⇒ General body repairs, exterior;
Rep. gr. 50 .
– Install heat shield.
– Assemble exhaust system free of tension and attach tunnel
cross member ⇒ Rep. gr. 26 ; Removing and installing parts
of exhaust system .
– Adjust selector mechanism
– If complete air filter housing was removed, install it ⇒ Rep. gr.
23 ; Repairing diesel direct injection system or ⇒ Rep. gr. 24 ;
Repairing injection system .
– Follow procedure after connecting battery ⇒ Electrical system;
Rep. gr. 27 ; Battery; Disconnecting and connecting battery .
1.10 Removing and installing gear selector
cable and gate selector cable
1.10.1 Removing
– Remove selector mechanism
80
Rep. gr.34 - Controls, housing
⇒ Item 26 (page 65) or
and
.
⇒ page 73
⇒ page 82 .
⇒ page 78 .
⇒ page 75 .