Volkswagen Golf Variant 2007 Workshop Manual page 239

1 - Gearbox housing
2 - Shim
❑ For differential
❑ Determining thickness
⇒ page 239
3 - Tapered roller bearing outer
race
❑ Pulling out ⇒ page 238
❑ Pressing in
⇒ page 238
4 - Tapered roller bearing inner
race
❑ Pulling off ⇒ page 237
❑ Pressing on
⇒ page 237
5 - Differential cage
❑ With riveted final drive
gear
6 - Tapered roller bearing inner
race
❑ Pulling off ⇒ page 237
❑ Pressing on
⇒ page 238
7 - Tapered roller bearing outer
race
❑ Pulling out ⇒ page 236
❑ Pressing in
⇒ page 237
8 - Washer
❑ Installation position:
shoulder on inner cir‐
cumference faces seal
⇒ Item 13 (page 235)
❑ Allocation ⇒ Electronic parts catalogue „ETKA"
9 - Clutch housing
10 - Countersunk bolt, 33 Nm
❑ Screw into threaded piece
11 - Right flange shaft
12 - Protective ring
❑ Pry protective ring off flange shaft with a screwdriver, alternating sides
❑ Install with indentation facing away from threaded hole in flange shaft
❑ Push on protective ring to stop by hand
❑ Protective ring must engage in flange shaft
13 - Seal
❑ For right flange shaft
❑ Allocation ⇒ Electronic parts catalogue „ETKA"
❑ Renewing with gearbox installed
14 - Compression spring for flange shaft
❑ Installed behind flange shaft
Golf Variant 2007 ➤ , Golf Variant 2010 ➤ , Jetta 2005 ➤ , Jetta 2011 ➤
⇒ Item 22 (page 236)
⇒ page 229
6-speed manual gearbox 02Q - Edition 06.2010
⇒ Item 11 (page 235)
3. Differential
235