Volkswagen Golf Variant 2007 Workshop Manual page 87

– Pull locking mechanisms on gate selector cable and gear se‐
lector cable end-pieces forward to stop -direction of arrow 1-
and then turn to left to lock -direction of arrow 2-.
Secure selector shaft as follows:
– Press selector shaft down -direction of arrow 1-.
– While pressing down selector shaft, turn angled rod -A- in
-direction of arrow 3- upwards and at the same time press it in
-direction of arrow 2- until it engages in selector shaft.
– Remove gaiter with selector knob and frame
– If noise insulation is present, remove it.
Now secure gear lever as follows:
– Select neutral using gear lever.
– Guide locking pin -T10027 A- through hole -A- into hole -B-.
– Check that gate and selector cables -B- are inserted, free of
tension, into locking devices -A-.
– Now turn locking mechanisms on gear selector cable and gate
selector cable end pieces clockwise to stop
-direction of arrow 1-.
The spring presses the locking mechanism into original position
-direction of arrow 2-.
Golf Variant 2007 ➤ , Golf Variant 2010 ➤ , Jetta 2005 ➤ , Jetta 2011 ➤
⇒ page 62
6-speed manual gearbox 02Q - Edition 06.2010
.
1. Repairing selector mechanism
83