Volkswagen Golf Variant 2007 Workshop Manual page 240

Golf Variant 2007 ➤ , Golf Variant 2010 ➤ , Jetta 2005 ➤ , Jetta 2011 ➤
6-speed manual gearbox 02Q - Edition 06.2010
15 - Thrust washer
❑ Installation position: shoulder faces spring, lugs, if present, face tapered ring
16 - Tapered ring
❑ Installation position: taper towards differential cage
17 - Retaining ring
❑ Holds tapered ring, thrust washer and spring in position when flange shaft is removed
18 - Sun wheel
❑ Installing ⇒ page 239
19 - Differential pinion pin
❑ Drive out using drift
❑ Installing ⇒ page 239
20 - Spring pin
❑ For securing differential pinion pin
❑ Removing and installing
21 - Planet pinion
❑ Installing ⇒ page 239
22 - Threaded piece
❑ Installing ⇒ page 239
23 - One-piece thrust washer
❑ Coat with gear oil when installing
24 - Protective ring
❑ Pry protective ring off flange shaft with a screwdriver, alternating sides
❑ Install with indentation facing away from threaded hole in flange shaft
❑ Push on protective ring to stop by hand
❑ Protective ring must engage in flange shaft
25 - Left flange shaft
26 - Seal
❑ For left flange shaft
❑ Allocation ⇒ Electronic parts catalogue „ETKA"
❑ Renewing with gearbox installed
Pulling tapered roller bearing outer race out of clutch housing
A - Counter support , e.g. -Kukko 22/2-
B - Internal puller, 46 ... 58 mm , e.g. -Kukko 21/7-
Note
After pulling out, renew washer.
236
Rep. gr.39 - Final drive - differential
⇒ page 238
⇒ page 227
⇒ Item 25 (page 236)