Volkswagen Golf Variant 2007 Workshop Manual page 148

Golf Variant 2007 ➤ , Golf Variant 2010 ➤ , Jetta 2005 ➤ , Jetta 2011 ➤
6-speed manual gearbox 02Q - Edition 06.2010
– Now press selector shaft -1- against stop sleeve -2- in
-direction of arrow- and guide downwards with selector finger
-3- through selector forks to stop.
• Selector shaft cover -4- must be parallel to bolting surface on
gearbox housing.
• Selector shaft must move freely in gate selection direction
(upwards and downwards).
Note
If selector shaft cover is tilted relative to bolting surface, selector
shaft is not inserted in lower bearing.
– Tighten bolts -3- for selector shaft cover -4-.
– Screw in locking bolt -2-, ensuring that angled rod -arrow- is
not engaged.
– Install reversing light switch -F4- -1-.
– Install left and right flange shaft with springs, thrust washers
and tapered rings.
– Drive in input shaft oil seal.
– Install slave cylinder with release bearing and tighten bolts
-arrows- to specified torque
– Shift through all gears.
144
Rep. gr.34 - Controls, housing
⇒ Item 4 (page 39) .