Assembly Overview - Pedal Cluster - Volkswagen Golf Variant 2007 Workshop Manual

Golf Variant 2007 ➤ , Golf Variant 2010 ➤ , Jetta 2005 ➤ , Jetta 2011 ➤
6-speed manual gearbox 02Q - Edition 06.2010
2.2

Assembly overview - pedal cluster

1 - Bulkhead
❑ With support for mount‐
ing bracket
2 - Seal
❑ Always renew
❑ Between mounting
bracket and bulkhead
❑ Self-adhesive
❑ Bond to mounting
bracket
3 - Mounting bracket
❑ For mounting clutch
pedal
❑ Is provided with damp‐
ing in some equipment
variants ⇒ page 15
❑ Removing and installing
⇒ page 23
4 - Bolt
5 - Over-centre spring
❑ Removing and installing
⇒ page 15
6 - Bearing bush
7 - Pivot pin
8 - Clutch pedal
❑ Removing and installing
⇒ page 19
9 - Retainer
❑ To remove and install,
separate master cylin‐
der from clutch pedal
⇒ page 19
10 - Seal
❑ Always renew
❑ Between master cylinder and mounting bracket
11 - Master cylinder
❑ Removing and installing after removal of mounting bracket
12 - Clutch position sender -G476-
❑ Removing and installing
❑ Can be checked using „guided fault finding" of vehicle diagnostic tester
❑ The clutch position sender -G476- is identified as clutch pedal switch -F36- in „guided fault finding"
13 - Clip
❑ Pull out clip to stop to remove and install pipe/hose line
14 - Supply hose
❑ Rubber
❑ From 12.05, plastic
15 - Hexagon nut, 25 Nm
❑ Self-locking
14
Rep. gr.30 - Clutch
⇒ page 30
⇒ page 35
⇒ page 29