Volkswagen Golf Variant 2007 Workshop Manual page 234

Golf Variant 2007 ➤ , Golf Variant 2010 ➤ , Jetta 2005 ➤ , Jetta 2011 ➤
6-speed manual gearbox 02Q - Edition 06.2010
♦ Drip tray for workshop hoist -VAS 6208-
♦ Sealing grease -G 052 128 A1-
1.2.1 Removing
– Remove noise insulation ⇒ General body repairs, exterior;
Rep. gr. 50 ; Noise insulation .
– Remove drive shaft heat shield from engine -arrows-, if fitted.
– Removing right drive shaft from gearbox flange shaft -A-
– Secure drive shafts with wire, taking care not to damage sur‐
face protection.
Note
With some engines, the drive shaft cannot be raised and se‐
♦
cured high enough that the flange shaft can be pulled out.
In that case, remove drive shaft ⇒ Running gear, axles, steer‐
♦
ing; Rep. gr. 40 ; Removing and installing drive shafts .
– Place drip tray under gearbox.
– Remove flange shaft securing bolt by screwing two bolts into
flange and counterholding flange shaft with a lever.
– Pull out flange shaft with compression spring.
– Pry seal out using assembly lever.
230
Rep. gr.39 - Final drive - differential