Removing And Installing Pipe/Hose Line Or Plastic Line - Volkswagen Golf Variant 2007 Workshop Manual

– Release securing clip -2- with a screwdriver or pointed object
and pull bleeder -4- off slave cylinder -1-.
– Remove bolts -arrows-.
– Remove slave cylinder together with release bearing -A-.
Installing
Install in the reverse order of removal, observing the following:
• The securing bolts for the slave cylinder must be tightened
only in small stages.
Otherwise, the tabs with the bolt holes may break off.
– Bolt on slave cylinder with release bearing
⇒ Item 4 (page 39) .
.
– Check O-ring -3- on slave cylinder for damage.
– Press bleeder -4- onto slave cylinder connection -1- until se‐
curing clip -2- engages audibly.
– Check by pulling on bleeder.
• Install gearbox.
– Bleed clutch system
3.3 Removing and installing pipe/hose line
or plastic line
Special tools and workshop equipment required
♦ Hose clamps to 25 mm -3094-
Golf Variant 2007 ➤ , Golf Variant 2010 ➤ , Jetta 2005 ➤ , Jetta 2011 ➤
⇒ page 37 .
6-speed manual gearbox 02Q - Edition 06.2010
3. Repairing clutch release mechanism
41