Volkswagen Golf Variant 2007 Workshop Manual page 173

❑ Removing and installing
❑ If renewed, adjust output shaft for 1st through 4th gears
12 - Tapered roller bearing outer race
❑ For output shaft for 5th, 6th and reverse gears
❑ Removing and installing
❑ If renewed, adjust output shaft for 5th, 6th and reverse gears
13 - Washer
❑ For output shaft for 5th, 6th and reverse gears
❑ Always 0.65 mm thick
14 - Cylindrical roller bearing
❑ For input shaft
❑ Removing and installing
15 - Magnet
❑ Held in place by housing joint surface
16 - Cap
❑ Not fitted in all clutch housings
Pulling out selector rod bearing bush
A - Counter support , e.g. -Kukko 22/1-
B - Internal puller, 14.5 ... 18.5 mm , e.g. -Kukko 21/2-
Driving in selector shaft bearing bush to stop of tool
Golf Variant 2007 ➤ , Golf Variant 2010 ➤ , Jetta 2005 ➤ , Jetta 2011 ➤
⇒ page 187
⇒ page 211
⇒ page 178
6-speed manual gearbox 02Q - Edition 06.2010
⇒ page 206
⇒ page 222
7. Repairing clutch housing
169