2
Output shaft for 1st through 4th gears
2.1
Assembly overview - output shaft for 1st
through 4th gears
Dismantling and assembling output shaft for 1st through 4th gears
⇒ page 187
.
Note
If output shaft or tapered roller bearings have been renewed, adjust output shaft
♦
Always renew both tapered roller bearings together as a set.
♦
1 - Clutch housing
2 - Oil deflector ring
3 - Dished washer
❑ Pulling out
⇒ page 192
❑ Pressing in
⇒ page 192
4 - Tapered roller bearing outer
race
❑ Pulling out
⇒ page 193
❑ Pressing in
⇒ page 193
5 - Tapered roller bearing inner
race
❑ Pressing off
⇒ page 192
❑ Pressing on
⇒ page 193
6 - Output shaft
❑ For 1st through 4th
gears
❑ Adjusting
⇒ page 206
7 - Needle bearing
❑ For 2nd gear
8 - Synchromeshed gear for
2nd gear
❑ 1st/2nd gear synchroni‐
sation modified from
gearbox date 26 10 9,
differentiation
⇒ page 195
9 - Synchro-ring (inner ring for
2nd gear)
❑ 1st/2nd gear synchronisation modified from gearbox date 26 10 9, differentiation
10 - Outer ring for 2nd gear
❑ 1st/2nd gear synchronisation modified from gearbox date 26 10 9, differentiation
11 - Synchro-ring for 2nd gear
❑ 1st/2nd gear synchronisation modified from gearbox date 26 10 9, differentiation
Golf Variant 2007 ➤ , Golf Variant 2010 ➤ , Jetta 2005 ➤ , Jetta 2011 ➤
6-speed manual gearbox 02Q - Edition 06.2010
2. Output shaft for 1st through 4th gears
⇒ page 206
.
⇒ page 195
⇒ page 195
⇒ page 195
185