Volkswagen Golf Variant 2007 Workshop Manual page 115

– Set up support bracket -10-222 A- in front of bonnet support.
– Use:
♦ Adapter -10-222 A /3-
♦ Adapter -10-222 A /8-
♦ Adapter -10-222 A /18-
– Position adapter -10-222 A /8- :
• On upper longitudinal carrier, directly before the elevation
(-arrow 1-) next to bolt (-arrow 2-)
– Connect engine and bracket -T10346- to support bracket .
– Take up weight of engine/gearbox assembly and support
bracket on spindles.
The left drive shaft will be removed in a later step.
– With vehicle standing on its wheels, loosen front left flange bolt
-arrow- 90° at most, or wheel bearing will be damaged ⇒
Running gear, axles, steering; Rep. gr. 40 ; Removing and
installing drive shafts .
– Remove noise insulation ⇒ General body repairs, exterior;
Rep. gr. 50 ; Noise insulation .
– Remove lower part of front left wheel housing liner ⇒ General
body repairs, exterior; Rep. gr. 66 ; Wheel housing liner .
– If front vehicle level sender -G78- is present, unbolt it from
transverse link ⇒ Rep. gr. 40 ; Removing and installing front
vehicle level sender -G78- .
– Remove bracket from starter.
– Remove starter ⇒ Electrical system; Rep. gr. 27 ; Starter .
– Remove left charge air hose -arrow 1- and -arrow 2- and
charge air pipe from engine ⇒ Rep. gr. 21 ; Charge air system
with turbocharger .
– Remove right charge air hose -arrow 2- ⇒ Rep. gr. 21 ; Charge
air system with turbocharger
Golf Variant 2007 ➤ , Golf Variant 2010 ➤ , Jetta 2005 ➤ , Jetta 2011 ➤
6-speed manual gearbox 02Q - Edition 06.2010
3. Removing and installing gearbox, vehicles with petrol engine
111