Golf Variant 2007 ➤ , Golf Variant 2010 ➤ , Jetta 2005 ➤ , Jetta 2011 ➤
6-speed manual gearbox 02Q - Edition 06.2010
Checking position of adjusting mechanism with new pressure
plates only
•
Both edges -A- of the adjuster ring must be located between
the two notches -arrows B-.
•
If the adjuster ring takes up a different position in new pressure
plates, the pressure plate and clutch plate are not allowed to
be installed.
•
The adjuster ring may take up a position outside the notches
in used clutches.
Note
Renew clutch plates and pressure plates with damaged or
♦
loose rivet connections.
Renew pressure plate and clutch plate together only.
♦
Select clutch plate and pressure plate according to engine
♦
code and ⇒ Electronic parts catalogue „ETKA" .
Clean input shaft splines and, on used clutch plates, clean hub
♦
splines; remove corrosion and apply only a very thin coat of
clutch plate spline grease -G 000 100- to splines. Then move
clutch plate to and fro on input shaft until hub moves freely on
shaft. Remove excessive grease.
Pressure plates are protected against corrosion and greased.
♦
Clean contact surface only. Otherwise, the service life of the
clutch will be considerably reduced.
Pressure plate contact surface and clutch plate lining must
♦
make full contact with flywheel. Only then insert securing bolts.
– Reverse counterhold tool -3067- for installation.
For engines having a crankshaft of smaller diameter -arrow- or
having an needle bearing -arrow- in the crankshaft
52
Rep. gr.30 - Clutch