Removing And Installing Mounting Bracket - Volkswagen ID.4 2021 Workshop Manual

ID.4 2021 ➤
Brake system - Edition 07.2021
– Fit clamping washer onto pivot pin.
– Continue installation in reverse order of removal.
5.4.2 Removing and installing brake pedal,
right-hand drive vehicles
Removing
– ⇒ Rep. gr. 46; Separate brake pedal from brake servo .
– Unscrew nut -2- from pivot pin -1- .
– Pull out pivot pin -1- towards left side in direction of -arrow- .
– Remove brake pedal from mounting bracket.
Installing
– Renew pivot pin and nut.
Important
• Do not lubricate or grease the pivot pin. The pivot pin must
remain dry.
– Push pivot pin from left side to right side through mounting
bracket and brake pedal.
– Screw nut onto pivot pin, and tighten it.
– Continue installation in reverse order of removal.
Tightening torques
♦ ⇒ Rep. gr. 46; Assembly overview – brake pedal
5.5 Removing and installing mounting
bracket
5.5.1 Removing and installing mounting
bracket, left-hand drive vehicles
Installing
– Remove dash panel cover on front passenger side ⇒ Gener‐
al body repairs, interior; Rep. gr. 68; Compartments/covers;
Removing and installing dash panel cover on front passen‐
ger side .
– Remove footwell vent on driver side ⇒ Heating, air condition‐
ing system; Rep. gr. 87; Air duct; Removing and installing
footwell vent on driver side .
62
Rep. gr.46 - Brakes - mechanism