Volkswagen Golf Variant 2007 Workshop Manual page 122

Golf Variant 2007 ➤ , Golf Variant 2010 ➤ , Jetta 2005 ➤ , Jetta 2011 ➤
6-speed manual gearbox 02Q - Edition 06.2010
– Ensure that intermediate plate is hooked into sealing flange
and pushed onto dowel sleeves -arrows-.
– Check release bearing for wear. If necessary, renew slave
cylinder with release bearing
– Attach bracket -T10346- with bolt -1- to left threaded hole in
subframe.
– In the process, position bracket -T10346- at the same angle
as the engine.
-1- = Flange bolt M6 x 20.
– Secure engine support -3300 A- to bracket -T10346- .
– Press engine forwards using spindle of engine support -3300
A- . In the process, observe the following points in particular:
• The air conditioning compressor -2- must not contact -arrow-
the refrigerant line -1-.
• The alternator must not contact the refrigerant line.
• The pressure pipe must not contact the radiator.
To install gearbox „02Q", set up gearbox support -3282- with ad‐
justment plate -3282/33- .
– Align arms of gearbox support according to holes in adjust‐
ment plate .
– Attach support elements -A- to adjustment plate as illustrated.
– Screw in pin -3282/29- instead of support element -C-.
– Place gearbox on engine and gearbox jack -V.A.G 1383 A- .
– Align adjustment plate and gearbox parallel to one another.
– Screw pin -3282/29- into hole on gearbox for securing bolt of
pendulum support.
118
Rep. gr.34 - Controls, housing
⇒ page 40 .