Volkswagen Golf Variant 2007 Workshop Manual page 186

Golf Variant 2007 ➤ , Golf Variant 2010 ➤ , Jetta 2005 ➤ , Jetta 2011 ➤
6-speed manual gearbox 02Q - Edition 06.2010
Pressing on deep groove ball bearing
Deep groove ball bearing with a rubber ring -arrow-
Shoulder -A- faces press tool -VW 412- .
Installation position of deep groove ball bearing
Groove for retaining ring faces upwards -arrow A- and shoulder
-arrow B- must face gear wheel for 5th gear.
– Determine and install retaining ring
Determining thickness of retaining ring
– Insert a 1.86 mm thick retaining ring -A- in groove of input shaft
and press upwards.
– Measure distance between deep groove ball bearing -B- and
installed retaining ring -A- using feeler gauge -C-.
– Remove retaining ring used for measuring purposes.
– Determine retaining ring from table.
Note
Allocate retaining rings according to ⇒ Electronic parts catalogue
„ETKA" .
The following retaining rings are available:
Measured value Retaining ring thick‐
(mm)
0.01...0.05
0.05...0.07
0.07...0.10
0.10...0.13
0.13...0.16
182
Rep. gr.35 - Gears, shafts
⇒ page 182
Axial play (mm)
ness (mm)
1.86 0.01...0.05
1.89 0.01...0.05
1.92 0.01...0.05
1.95 0.01...0.05
1.98 0.01...0.05
.